#FTECU QUICKSHIFT SENSOR INSTALL#
#FTECU QUICKSHIFT SENSOR UPDATE#
#FTECU QUICKSHIFT SENSOR FULL#

Bike-side programming harness to permanently install on your bike.

See screen shot for list of current featuresДata-Link ECU Flashing Bike Side Kit Includes:.

Cylinder Specific Ignition Timing by Gear.

*This kit is also compatible with the R1M and R1SДЇlash Tune Data-Link (Bike side) ECU Flashing Kits for the 2019 Kawasaki ZX-6R + 2017-2019 Z900 : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Note: Bike side kit attaches to the bike to allow lap top access with the included tuning cable.

Low Load (cruising) Fuel Maps and Bias Mapping.

High Load Fuel Maps (PC5 map importing).

#FTECU QUICKSHIFT SENSOR UPDATE#

By flashing your ECU you are able to tune your bike without interfering with critical correction factors resulting in smoother power gains than ever before possible.This product is for RACE USE ONLY! The included software will automatically update as new features are added! With the FTEcu software you can remove the restrictions that the factory must put in place to meet strict street vehicle guidelines. We believe everyone deserves the same tuning technology that until now was reserved for factory riders.

FT ECU License to allow unlimited flashes for a single ecu.

Bench Flashing Harness to flash your ECU outside of the bike.High Load Fuel Maps (with PC3 and PC5 map importing).This Interface allows you to easily adjust the following! The 2013-2017 Kawasaki Ninja EX300 Flash Tune Data-Link ECU Flashing Kits : Your bike already has a standalone ECU and now you can get the tools to program it! There is no longer any need to send away your ECU! Kawasaki ZX-6R 2019 Note: You will need an 18x1.5mm Lamda Collar in your exhaust for this installation.Kawasaki H2 2015+ Note: You will need an 18x1.5mm Lamda Collar in your exhaust for this installation.

#FTECU QUICKSHIFT SENSOR FULL#

Kawasaki ZX10 2016-2019 Note: You will need an 18x1.5mm Lamda Collar in your ZX10 exhaust for this installation this does not come on the stock exhausts but standard on Graves Cat Eliminator and Full Exhaust Systems.

Smog block-offs or disabled AIS valve (Graves Smog Block Off plates listed separately).

Exhaust with a standard 18Г—1.5 O2 sensor bung (optionally cylinder specific bungs).

Data-Link ECU Flashing Kit ( bike harness required for tuning / data acquisition ).

This breakthrough system replaces your inadequate stock O2 sensor with a proprietary FTECU lambda controller and the latest generation Bosch LSU 4.9 sensor. This Kit lets your FTECU equipped bike tune itself as you ride! Once installed and activated, the ActiveTune kit monitors the fuel mixture making fast and consistent changes to mitigate changing fuel requirements. FTEcu Kawasaki Active Tune AFR Self Tuning ECU Kit.

Ftecu quickshift sensor